RAMPS compatible LCD controller module (HC3DPR0005)

Products related to 3D printing and CNC machines.
andrew
Site Admin
Posts: 1374
Joined: Sun Aug 05, 2012 4:15 pm

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Post by andrew » Sat Jan 10, 2015 8:39 am

That is a good point, you could use the adaptor board from your other shield that would at least rule out any physical faults apart from the panel itself.
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.

ThierryM
Posts: 9
Joined: Sun Jan 04, 2015 2:47 pm
Location: France

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Post by ThierryM » Sat Jan 10, 2015 8:56 am

Hi,
I've tested all the pins with my working adaptor as model : I've the same results -> the adaptor seems good.
I can't use my working adaptor with your module because the ribbon cables are reverse protected and the plugs aren't in the same direction.
Reprap Prusa V2 + Ramps 1.4 + Marlin with autoleveling bed

andrew
Site Admin
Posts: 1374
Joined: Sun Aug 05, 2012 4:15 pm

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Post by andrew » Mon Jan 12, 2015 10:50 am

Ok, we've just about exhausted other possibilities so I think we may have to consider that there is a problem with the panel itself. If it was purchased from us just email sales (at) hobbycomponets.com and we will deal with it from there.
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.

ThierryM
Posts: 9
Joined: Sun Jan 04, 2015 2:47 pm
Location: France

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Post by ThierryM » Wed Feb 04, 2015 3:20 pm

Hi,
I've tested with a HC3DPR0006 module (bought here with the discount) and I haven't any problem : this SD card reader works fine.
So the SD card reader of the HC3DPR0005 was effectively faulty.
Regards,

Thierry
Reprap Prusa V2 + Ramps 1.4 + Marlin with autoleveling bed

andrew
Site Admin
Posts: 1374
Joined: Sun Aug 05, 2012 4:15 pm

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Post by andrew » Fri Feb 06, 2015 8:37 am

That's good to hear. My suspicion with the other display is that there is a physical problem with the SD card connector itself.
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.

ILYBTodd
Posts: 44
Joined: Mon Nov 05, 2018 6:20 pm

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Post by ILYBTodd » Thu Jun 06, 2019 5:31 pm

Is there a dimensional drawing available ?

andrew
Site Admin
Posts: 1374
Joined: Sun Aug 05, 2012 4:15 pm

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Post by andrew » Fri Jun 07, 2019 8:25 am

Here you go...
RAMPS_Compatible_LCD_HC3DPR0005_Dimensions.png
You do not have the required permissions to view the files attached to this post.
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.

Post Reply

Return to “3D Printing / CNC”