forum.hobbycomponents.com

Code: Select all

/* FILE:    ATmega32_Development_board_Test_Program.cpp
   DATE:    19/07/13
   VERSION: 0.1
   
REVISIONS:

19/07/13 Created version 0.1


This is a simple program that will slowly flash the on board LED connected 
to DIO pin PB0 repeatedly.  

You may copy, alter and reuse this code in any way you like, but please leave
reference to HobbyComponents.com in your comments if you redistribute this code.
This software may not be used directly for the purpose of selling products that
directly compete with Hobby Components Ltd's own range of products.

THIS SOFTWARE IS PROVIDED "AS IS". HOBBY COMPONENTS MAKES NO WARRANTIES, WHETHER
EXPRESS, IMPLIED OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ACCURACY OR LACK OF NEGLIGENCE.
HOBBY COMPONENTS SHALL NOT, IN ANY CIRCUMSTANCES, BE LIABLE FOR ANY DAMAGES,
INCLUDING, BUT NOT LIMITED TO, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR ANY
REASON WHATSOEVER.
*/


#include <avr/io.h>

/* Used to create a very simple delay loop */
long Delay;

int main(void)
{
   /* Set all port B pins to outputs */
   DDRB = 0xff;

   while(1)
   {
      /* Set DIO pin PB0 high */
      PORTB = 0b00000001;
      /* Wait a little */
      for(Delay=0; Delay <=50000; Delay++);
 
      /* Set DIO pin PB0 low */
      PORTB = 0b00000000;
      /* Wait a little */
      for(Delay=0; Delay <=50000; Delay++);
   }

return 1;
}