forum.hobbycomponents.com

Hello, I've recently bought the Ed Tracker kit pre soldered. Fitted it to the case, but upon inserting the cable (micro usb) the port has come away from the board. Is this board now useless, or , is there some hope of repairing this. I'm more than abit annoyed really, as although I was care ful and spotted straight off it was a delicate fitting, it doesn't really seem up to scratch in it's current form. Any advise or help would be gratefully received thankyou. Ry889

Sorry to hear this. The possibility of repairing it will depend of if the pads for the connector are still attached to the PCB and have not been pulled away? Would it be possible to take a picture of the pads and email it to our support address (support [at] hobbycomponents.com)? Thanks.