Arduino Pro Micro - Ed Tracker

Forum for posting topics and questions about anything.
Post Reply
ry889
Posts: 1
Joined: Sat Sep 26, 2020 6:30 am

Arduino Pro Micro - Ed Tracker

Post by ry889 » Sat Sep 26, 2020 6:48 am

Hello, I've recently bought the Ed Tracker kit pre soldered. Fitted it to the case, but upon inserting the cable (micro usb) the port has come away from the board. Is this board now useless, or , is there some hope of repairing this. I'm more than abit annoyed really, as although I was care ful and spotted straight off it was a delicate fitting, it doesn't really seem up to scratch in it's current form. Any advise or help would be gratefully received thankyou. Ry889

andrew
Site Admin
Posts: 1374
Joined: Sun Aug 05, 2012 4:15 pm

Re: Arduino Pro Micro - Ed Tracker

Post by andrew » Sun Sep 27, 2020 8:38 am

Sorry to hear this. The possibility of repairing it will depend of if the pads for the connector are still attached to the PCB and have not been pulled away? Would it be possible to take a picture of the pads and email it to our support address (support [at] hobbycomponents.com)? Thanks.
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.

Post Reply

Return to “General Discussion”