I just purchased a tinyduino processor board [ASM2001-R-L] (with the lithium battery option) and a tinyshield [ASD2101-R]. I plugged in the battery, turned on the switch, and then connected my tinyshield. The light on the main board comes on - and that's all that happens. There's no response from the system showing this board. I installed the software/drivers, but I don't see it. This cable is definitely good; I tried two other cables, but the board LED doesn't come on with them; with this cord, it does. I'm assuming, therefore, that the cable is good.
Any ideas why this isn't being detected? I already have a device on COM3; do I need to remove it?
NOTE: These were not purchased here.
Forum for posting topics and questions about anything.
1 post • Page 1 of 1