ATMega328-PU IC (HCCOIC0028)

Post Reply
admin
Site Admin
Posts: 866
Joined: Sun Aug 05, 2012 4:02 pm

ATMega328-PU IC (HCCOIC0028)

Post by admin » Sat Aug 10, 2013 2:02 pm

Image

The ATMega328-PU sold by us is used in Arduino Uno development boards and is pre-programmed with the Arduino Uno bootloader. This makes this device ideal for use in your own projects or as a replacement for a damaged Uno.

The high-performance Atmel 8-bit AVR RISC-based microcontroller combines 32KB ISP flash memory with read-while-write capabilities, 1KB EEPROM, 2KB SRAM, 23 general purpose I/O lines, 32 general purpose working registers, three flexible timer/counters with compare modes, internal and external interrupts,serial programmable USART, a byte-oriented 2-wire serial interface, SPI serial port, 6-channel 10-bit A/D converter (8-channels in TQFP and QFN/MLF packages), programmable watchdog timer with internal oscillator, and five software selectable power saving modes. The device operates between 1.8-5.5 volts.

By executing powerful instructions in a single clock cycle, the device achieves throughputs approaching 1 MIPS per MHz, balancing power consumption and processing speed.

Flash (Kbytes): 32 Kbytes
Pin Count: 32
Max. Operating Frequency: 20 MHz
CPU: 8-bit AVR
Number of Touch Channels: 16
Max I/O Pins: 23
Ext Interrupts: 24
SPI: 2
TWI (I2C): 1
UART: 1
ADC channels: 8
ADC Resolution (bits): 10
ADC Speed (ksps): 15
Analog Comparators: 1
Temp. Sensor: Yes
SRAM (Kbytes): 2
EEPROM (Bytes): 1024
Self Program Memory: YES
Temp. Range (deg C): -40 to 85
I/O Supply Class: 1.8 to 5.5
Operating Voltage (Vcc): 1.8 to 5.5
Timers: 3
Output Compare channels: 6
Input Capture Channels: 1
PWM Channels: 6
32kHz RTC: Yes
Calibrated RC Oscillator: Yes

Pinout
Image

Datasheet
A full datasheet can be downloaded here.

Post Reply

Return to “ICs”