I bought a kit Reference: HCPROT0085. Do you sell any suitable crimping tool for these?
I bought one from ebay (ref. as SN 28B), but the result is not good enough really...
Once crimped on a wire, the crimp is too flat and too wide to even get into the housing!
I could do with a proper one.
2 posts • Page 1 of 1
We don't at the moment I'm afraid. I don't know if this will help but If you've not got many to do I just use a small pair of needle-nose pliers. I use the end of the pliers to fold over each tab one at a time and then put them in between the pliers to crimp them.
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.