1 post • Page 1 of 1
These low cost plastic control caps (HCREVA0009) are excellent for potentiometers with a shaft diameter of 6mm (0.6cm). Made from injection moulded plastic the caps are approximately 15mm diameter across the bottom and taper to 11mm at the top. They are 14.5mm high, and so make the standard shaft of a potentiometer easier to handle. This item is suitable for our panel mountable potentiometer (HCREVA0007). The cap is designed to be pushed onto the potentiometer and will remain firmly in place without requiring any glue or fixing screws.
Max External Diameter (approx): 15mm (1.5cm)
Top Diameter (approx): 11mm (1.1cm)
Height (approx): 14.5mm (1.6cm)
Diameter for potentiometer shaft (approx): 6mm (0.6cm)
(Potenetiometer not included)