Page 1 of 1

Prototyping HAT for Raspberry Pi (HCRASP0007)

Posted: Thu Apr 07, 2016 10:34 am
by admin

This bundle allows you to create your own Pi HAT by attaching custom circuitry. The PCB itself has a grid of 0.1” prototyping holes for attaching ICs, resistors, LEDs, potentiometers etc. The holes are connected on the underside of the board, which mimics solderless breadboard prototyping, so it's great if you're used to prototyping with breadboard.

There are also power strips for +3V, +5V and GND (Ground) connections to your Pi.

Each bundle contains the following items:
1 x Prototyping HAT PCB
1 x Double row 20 Pin Header
4 x Nuts
4 x Screws
4 x Spacers