forum.hobbycomponents.com

its pairing but it wont connect to my samsung tablet Could you confirm that it is pairing with this tablet? If so, although your tablet may have successfully paired with the slave module, it wont link to it until you actually open a serial terminal connection on your tablet. If you still have no lu...

I've updated the datasheet in the first post.

It would probably need a lot of modification. The 5110 uses a different driver and interface to the SH1106. It may be possible to write a wrapper or modify the low level functions that write to the display but because the screens are also different resolutions you would probably have to modify other...

The manufacturer doesn't provide instructions but you can reference the pictures in this thread to give you an idea of how it all goes together. Note that sometimes the manufacturer will provide spare parts with the kit. You can use the following screws/nuts provided in the kit as follows: For all a...

It sounds like a bad connection issue to me. I would double check that you have good connections to the module, especially the GND connection (VSS). Is the module on long wires? If so then try shortening them. Also in the example you posted, if you're only wanting to display something that changes e...

@AshHalfheart

There is a new version of PulseView available. I've just tested it on a clean install of Windows 8 and I can confirm that it is working fine. If your still seeing this issue try installing the latest version.

3.3v -- (Not connected) GND -- GND VBUS -- VCC TXD -- RXI RXD -- TXO DTR -- DTR That looks correct to me. "CDM v2.10.00 WHQL Certified.zip" from the FTDI website and I now see "USB Serial Port (COM6)" in Device Manager. Again this seems like the driver is installed correctly. On the Pro Mini, there...

The message was not Installation Complete but 'the best driver software is already installed' In Properties it is listed as a FTDI on USB Serial Converter. That seems ok to me but a tip if you want force windows to reinstall the driver is to locate the device in device manager, right click on and a...

I've switched it to 5V supply and now I can set my date and time!! How is this possible?? Ah, that will be the problem. A Mega needs a minimum of about 3V at its digital pin to see it as a logic high. If you power the RTC from a 3.3V supply then a logic high from the RTC will be just under 3V so it...

I can see that you have bought two FTDI adaptors from us but can I just confirm that you have tried two FTDI adaptors and they are the ones purchased from us? The reason I ask is that the VID and PID you're seeing doesn't match the ones for our adaptors. If it is one of our FTDI based adaptors then ...