Search found 5 matches

by Totoche95
Wed Apr 29, 2015 2:17 pm
Forum: Microchip
Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
Replies: 109
Views: 131078

Re: Pic - K150 ICSP Programmer (HCDVBD0002)

Yes but as they are connedted on ICMP, they are also on socket, i don't know if it is normal.
The 16F628 with 18 pins is ok but with more pins 12V will be on pin it must not to be.
Cheers
Yves
by Totoche95
Sat Apr 25, 2015 4:16 am
Forum: Microchip
Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
Replies: 109
Views: 131078

Re: Pic - K150 ICSP Programmer (HCDVBD0002)

Hello, i found why, the voltage on reset pin of the pic was 1.5 V with K150 connected because VPP1 and VPP2 are connected together to VPP of ICSP with two 10K to ground. My reset resistor was also 10K so i had 1.5V. Finaly i put a diode on VPP and i have 5 V on reset input and my PIC restart after p...
by Totoche95
Fri Apr 24, 2015 3:21 pm
Forum: Microchip
Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
Replies: 109
Views: 131078

Re: Pic - K150 ICSP Programmer (HCDVBD0002)

Thanks for your reply.
I tried with your software (that is the same as mine), same problem so it is hardware of TS-8900 K150. But it is not so bad, i just have to connect and disconnect ICSP connector each time i program the PIC. It works fine for the other.
Cheers
Yves
by Totoche95
Wed Apr 22, 2015 2:22 pm
Forum: Microchip
Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
Replies: 109
Views: 131078

Re: Pic - K150 ICSP Programmer (HCDVBD0002)

Thanks for your reply. My card has a 16F628A, the same as the K150 programmer , my Microburn software is V150807 version with P18A protocol. The programmer is a TS8900-K150 with P18A firmware. All works fine, i can program also by ICSP but i have to disconnect ICSP connector to run the card, if not ...
by Totoche95
Tue Apr 21, 2015 7:41 pm
Forum: Microchip
Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
Replies: 109
Views: 131078

Re: Pic - K150 ICSP Programmer (HCDVBD0002)

Hello,
I have a K150 since a week, it works and it can also program PIC by ICSP. Just one thing, is there a solution to let ICSP connected after programming, when PIC is running. I have to disconnect ICSP to run my PIC card , it would be fine to let K150 connected.
Cheers
Yves