Ultimate RFID Kit (HCARDU0068)

RFID kits, modules and tags
Post Reply
admin
Site Admin
Posts: 725
Joined: Sun Aug 05, 2012 4:02 pm

Ultimate RFID Kit (HCARDU0068)

Post by admin » Fri Jul 26, 2013 9:40 am

Image to be added shortly.

The Hobby Components Ultimate RFID Kit contains:

• 1 X Arduino compatible R3 Uno board
• 1 X USB Cable
• 1 X breadboard
• 1 X breadboard jumper wire
• 5 X 2N2222 transistors
• 1 X IC Keychain
• 1 X Non-contact IC card
• 1 X RFID 13.56 Mhz Module
• 1 X i2c 1602 LCD with I2C serial cable
• 1 X V5 Sensor Shield
• 1 X 4*4 Matrix Keypad
• 1 X 12V Voice receiver Module
• 1 X LM35 Sensor module
• 1 X digital tilt sensor
• 1 X 8*8 Matrix LEDs
• 1 X IR controller
• 1 X IR receiver
• 1 X IR sender
• 1 X AT24C64 EEPROM Chip
• 1 X 74HC595N
• 1 X DS1307 RTC Chip
• 1 X 32.768 KHz watch crystal
• 1 X CR2032 battery socket
• 1 X 5V Relay
• 1 X 5V Buzzer
• 1 X 10K Photoresistor
• 1 X 10K potentiometer
• 10 X Green 3mm LEDs
• 10 X Yellow 3mm LEDs
• 10 X Red 3mm LEDs
• 10 X 220 ohm Resistors
• 10 X 1K ohm Resistors
• 10 X 10K ohm Resistors
• 1 X 9V battery cable
• 1 X 7seg-4digit LED display
• 1 X 3V-6V motor
• 5 X 1N4001 Diode
• 2 X 100nF capacitor

Please note that this item is Arduino compatible. Arduino is an open standard and the board(s) contained in this kit have been built exactly to the Arduino open source reference design. It also contains the same boot loader and is therefore identical in design, build and software to an original board. The only significant difference is the price. All our Arduino boards are built and tested at the same factory. We have now sold hundreds of Arduino boards and have an almost insignificant return rate. Of course, if you are not happy with your order you can return it back to us for any reason within 14 days of receiving it. If you require help we are always more than happy to offer assistance.

Post Reply