Reply to topic  [ 3 posts ] 
MAX485 RS485 transceiver module (HCMODU0081) 
Author Message
Site Admin

Joined: Sun Aug 05, 2012 4:02 pm
Posts: 716
Post MAX485 RS485 transceiver module (HCMODU0081)

Order yours here


This low power transceiver module is based on the Maxim MAX485 IC to allow serial communication over very long cable runs (up 4000 feet / 1200 meters). Serial data can be transmitted in both directions (half duplex) at a data rate up to 2.5Mbps. The modules operate from a standard 5V power supply and use 5V logic levels allowing them to be interfaced to the hardware serial ports of microcontrollers such as Arduino/PIC etc. Direction of communication can be controlled with just one digital pin (see diagram). It is also possible to connect multiple modules together for communication between 2 or more devices. For even greater distances two modules can be configured as a repeater.

Each module contains one driver and one receiver. Drivers are short-circuit current limited and are protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a high-impedance state. The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit.

Data connections to the modules are provided by a standard 0.1" pitch header pins which can also be soldered into standard prototyping PCB and breadboards. Screw terminals provide convention connection to the actual data cable.


A............Non-inverting Receiver Input and No-ninverting Driver Output.
B............Inverting Receiver Input and Inverting Driver Output

R0..........Receiver Output (to Rx pin of microcontroller)
RE..........Receiver Output Enable (Low to enable)
DE..........Driver Output Enable (high to enable)
DI...........Driver Input (to Tx pin of microcontroller)




You do not have the required permissions to view the files attached to this post.

Wed Jul 22, 2015 10:04 am

Joined: Mon Mar 05, 2018 6:45 pm
Posts: 1
Post Re: MAX485 RS485 transceiver module (HCMODU0081)
i'm having problem with this module. It does transmit, but does not receive. Have measured signal with osciloscope and found, that RX falls from 5 VDC to 3,5 VDC. Microprocessor can not read 3,5 VDC as 0. Have removed all resistors ( except R7 and R8 ), doesn't help, result is the same. Any ideas ?
with regards, Branko

Tue Mar 06, 2018 9:19 am
Site Admin

Joined: Sun Aug 05, 2012 4:15 pm
Posts: 781
Post Re: MAX485 RS485 transceiver module (HCMODU0081)
i'm having problem with this module.

I can't seem to find your order from your forum account details, was it purchased from us?

Any ideas ?

The modules are half duplex in that they can only transmit in one direction at a time. Are controlling the DE and RE pins to switch the Tx/Rx to the correct direction?

Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.

Tue Mar 06, 2018 11:11 am
Display posts from previous:  Sort by  
Reply to topic   [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Thank you to &
Design created by Florea Cosmin Ionut.
© 2011 All contents of this site are © Hobby Components LTD