MK2B Dual Power Heatbed, Cable, Resistor & LEDs (HC3DPR0030)

Products related to 3D printing and CNC machines.
Post Reply
admin
Site Admin
Posts: 725
Joined: Sun Aug 05, 2012 4:02 pm

MK2B Dual Power Heatbed, Cable, Resistor & LEDs (HC3DPR0030)

Post by admin » Tue Jul 26, 2016 3:31 pm

Image



This heatbed is designed to be compatible with any 3D printer that can accept the RAMPS MK2B version of heatbed. This heatbed has a dual power capability allowing it to be used with 12V or 24V power supply sources (these are soldered for use as a 12V PCB). It has a central mounting hole on the front side to allow for three point mounting. This is much easier for bed levelling in comparison to 4 point mounting. Additionally, the solder pads have been greatly increased in size, making it much easier and allowing for the use of 1206 surface mount components, which have already been soldered for you. The power cables are also already soldered into place. Please note however, that this does not remove the need to use proper strain relief.

Image
Image shows power cable, resistor and LEDs already soldered.

Specification

Dimensions (Outer): 214mm x 214mm
Dimensions (Heat Bed): 200mm x 200mm
Resistance (12V): 0.9 - 1.6 Ohms
Resistance (24V): 3.5 - 5.9 Ohms
Operating voltage: 12 or 24 Volts
Operating current (12V): 7.4 - 12.7 Amps
Operating current (24V): 4.1 - 6.6 Amps
Wattage (Typ): 115W (12V) / 120W (24V)

Heat Map
Image

* Temperature in Degrees Centigrade. Measured at 25oC ambient room temperature. Heatbed soaked at maximum current for 15 minutes. Underside of heatbed was insulated

Post Reply