Page 2 of 2

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Posted: Sat Jan 10, 2015 8:39 am
by andrew
That is a good point, you could use the adaptor board from your other shield that would at least rule out any physical faults apart from the panel itself.

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Posted: Sat Jan 10, 2015 8:56 am
by ThierryM
Hi,
I've tested all the pins with my working adaptor as model : I've the same results -> the adaptor seems good.
I can't use my working adaptor with your module because the ribbon cables are reverse protected and the plugs aren't in the same direction.

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Posted: Mon Jan 12, 2015 10:50 am
by andrew
Ok, we've just about exhausted other possibilities so I think we may have to consider that there is a problem with the panel itself. If it was purchased from us just email sales (at) hobbycomponets.com and we will deal with it from there.

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Posted: Wed Feb 04, 2015 3:20 pm
by ThierryM
Hi,
I've tested with a HC3DPR0006 module (bought here with the discount) and I haven't any problem : this SD card reader works fine.
So the SD card reader of the HC3DPR0005 was effectively faulty.
Regards,

Thierry

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Posted: Fri Feb 06, 2015 8:37 am
by andrew
That's good to hear. My suspicion with the other display is that there is a physical problem with the SD card connector itself.

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Posted: Thu Jun 06, 2019 5:31 pm
by ILYBTodd
Is there a dimensional drawing available ?

Re: RAMPS compatible LCD controller module (HC3DPR0005)

Posted: Fri Jun 07, 2019 8:25 am
by andrew
Here you go...
RAMPS_Compatible_LCD_HC3DPR0005_Dimensions.png