Need help with design. Linear actuator and Arduino

Forum for posting topics and questions about anything.
Post Reply
tinkervoid
Posts: 1
Joined: Mon Dec 10, 2018 11:48 pm

Need help with design. Linear actuator and Arduino

Post by tinkervoid » Mon Dec 10, 2018 11:56 pm

I've attached a picture below as reference to the 3d files I've generated myself on CAD. As seen in the photo, you place a can into this device and push down the small tool on top to make a proper hole in the can. I've replicated this design in CAD and am currently trying to figure out how to automate it. I was thinking about a linear actuator but I cannot seem to find anything that would be powerful enough. Any ideas?
You do not have the required permissions to view the files attached to this post.

Post Reply

Return to “General Discussion”