Need help with design. Linear actuator and Arduino

Forum for posting topics and questions about anything.
Post Reply
tinkervoid
Posts: 1
Joined: Mon Dec 10, 2018 11:48 pm

Need help with design. Linear actuator and Arduino

Post by tinkervoid » Mon Dec 10, 2018 11:56 pm

I've attached a picture below as reference to the 3d files I've generated myself on CAD. As seen in the photo, you place a can into this device and push down the small tool on top to make a proper hole in the can. I've replicated this design in CAD and am currently trying to figure out how to automate it. I was thinking about a linear actuator but I cannot seem to find anything that would be powerful enough. Any ideas?
You do not have the required permissions to view the files attached to this post.

Post Reply