forum.hobbycomponents.com
http://forum.hobbycomponents.com/

Running a DC motor from ecig mod
http://forum.hobbycomponents.com/viewtopic.php?f=49&t=2386
Page 1 of 1

Author:  oobjwoo [ Fri Jan 05, 2018 2:36 pm ]
Post subject:  Running a DC motor from ecig mod

Hello friends,

As you will see I'm new here, I'm from the UK...recently started to get bored so have decided to start this hobby of messing around robotics and metalworking/woodworking (nothing to heavy as of yet) and selling my projects for extra income. Really starting to enjoy it as well.

I have a question though, from the title, I'd like to know if I can run a 12v dc motor (taken from a battery drill) with a ecig mod. It uses about 50mA when running as doesn't have any load and pulls about 15+ A when under load and anything in-between.

I have a an old smok alien mod, the idea of this isn't to keep running the motor constantly and putting in under load but of a testing facility to quickly plugin----test motor----unplug/solder----test----unplug/solder----test, and so on.

I was wondering if I connect wires to where the coil (RBA) would normally go would this spin the motor when I press the fire-up button on the mod, I ask this as I already have all the equipment but also this mod is easy to charge, small, easy on/off, etc...

What do you guys think?

Thanks

Author:  oobjwoo [ Mon Jan 15, 2018 9:15 am ]
Post subject:  Re: Running a DC motor from ecig mod

Does anyone have any idea's about this ?

Author:  MichaelSty [ Sat May 05, 2018 11:31 am ]
Post subject:  Re: Running a DC motor from ecig mod

Not tried anything like this myself, but it's an interesting idea for sure. Did you make any progress btw?

Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/