hi all, I've bought the edtracker diy bundle,brought to a professional who soldered as said on site, unfortunately when i start the gui although everything is detected, like the arduino port, after flashing no data appears.what I mean is that on the arduino I get a red led on, on the other board i get two steady red leds on and a flashing red light going on and off...... I don't get any yellow or green light on.
I don't know what can be wrong. I can send pictures although everything is soldered as it should. the monitoring is extremely slow and it detects only temperature..... no gyros.... any help?
edtracker bundle not working
Re: edtracker bundle not working
Sorry to hear this. It may be worth sending a picture as I may be able to spot something wrong. However if you are getting temperature sensor data then I doubt there is anything wrong with the soldering. I notice you bought the GY-521/MPU6050 version. Can I confirm that when you flashed the Pro Micro you selected 'EDTracker2_6050 2.20.9' as the firmware version' ?
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.
-
- Posts: 4
- Joined: Thu Dec 28, 2017 7:34 pm
Re: edtracker bundle not working
As for the temperature, everytime it detects different values, sometimes 5000 plus other times 36 or about it and other times 0.
as you can see the gui is not working properly,or at least as i have seen on tutorials on line.... really don't know what to do. but I love the idea of using your product for simulation flights. here are the pictures when the arduino is connected to the pc
You do not have the required permissions to view the files attached to this post.
Re: edtracker bundle not working
Thanks for the images. In the last image that shows attempt to flash the device I can see an error message. Do you get this error every time you try to flash the device? If so can you open up device manager and check if the Pro Micro is listed. It should be listed under the category Ports(COM & LPT). If it is listed do you see any error messages beside it?
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.
-
- Posts: 4
- Joined: Thu Dec 28, 2017 7:34 pm
Re: edtracker bundle not working
starts but extremely slow and without detecting other imput a part temperature and also in this case the values of the temperature are really strange, sometimes 6000 sometimes 36 sometimes 0.......
You do not have the required permissions to view the files attached to this post.
Re: edtracker bundle not working
Thanks again. Just for reference, for your version of EDTracker the correct version of firmware is the one titled 'EDTracker2_6560 2.20.9'. Don't bother trying the 9150/9250 versions as these are not compatible with your version of accellerometer and it will just hang at the initial 'calibrating gyro bias' stage. That said it looks like this is some odd connection or accellerometer issue. If you can confirm that it still doesn't work with the above mentioned 6560 firmware version then I'll contact you via email to try and resolve the problem.
Comments made by this poster do not necessarily reflect the views of Hobby Components Ltd.
-
- Posts: 4
- Joined: Thu Dec 28, 2017 7:34 pm
Re: edtracker bundle not working
Hi Andrew I've followed your last suggestion, unfortunately it didn't work. this is my email [email address removed by admin]
Hope we can solve the problem, thank you!
Hope we can solve the problem, thank you!
You do not have the required permissions to view the files attached to this post.