Microduino ENC28J60 Ethernet Module with PoE (HCMIDU0004)

Microduino products. *** DISCONTINUED ***
Post Reply
admin
Site Admin
Posts: 866
Joined: Sun Aug 05, 2012 4:02 pm

Microduino ENC28J60 Ethernet Module with PoE (HCMIDU0004)

Post by admin » Sat Jun 01, 2013 6:09 pm

Image
Image

Description:

The Microduino-ENC28J60 ethernet module with PoE capability uses MicroChip 's high performance single-chip SPI bus network interface chip which is an IEEE 802.3-compliant Ethernet controller integrated MAC and 10BASE-T PHY. It supports full and half-duplex mode.

This module easily stacks on top of a Microduino-Core or Core+ board giving it IEEE 802.3 networking capability.


Characteristics:

U-shaped 27pin Microduino standard interface, with Microduino-RJ45 conntector.

The ENC28J60 network chip has strong support within the Arduino community with Libraries and example sketches already in existence.


Specification:

ENC28J60 Ethernet chip, SSOP28 package
IEEE 802.3-compliant Ethernet controller integrated MAC and 10 BASE-T PHY
Support full-duplex and half-duplex mode
SPI interface, SPI clock can be up to 20MHZ, maximum speed up to 10Mb / s SPI interface
Single-supply operation: 3.3V
Murata ceramic crystal 25Mhz
Dimensions: Length Width 25.4mm X 27.94mm.

PoE Supply Voltage: 9-12V
Maximum current: 500mA (300mA recommended)

Microduino-ENC28J60 Interface:
VCC-> 3V3
GND-> GND
CS-> D8
SI-> D11
SO-> D12
SCK-> D13
INT-> D2 (optional, need to connect R3 (0-2K))
RST-> RST


Schematic:
HCMIDU0005_Microduino_ENC28j60_Schematic.png

Compatible Arduino Library:

https://github.com/jcw/ethercard
ethercard-master.zip
You do not have the required permissions to view the files attached to this post.

Post Reply

Return to “Microduino”