Yes but as they are connedted on ICMP, they are also on socket, i don't know if it is normal.
The 16F628 with 18 pins is ok but with more pins 12V will be on pin it must not to be.
Cheers
Yves
Search found 5 matches
- Wed Apr 29, 2015 2:17 pm
- Forum: Microchip
- Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
- Replies: 132
- Views: 254813
- Sat Apr 25, 2015 4:16 am
- Forum: Microchip
- Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
- Replies: 132
- Views: 254813
Re: Pic - K150 ICSP Programmer (HCDVBD0002)
Hello, i found why, the voltage on reset pin of the pic was 1.5 V with K150 connected because VPP1 and VPP2 are connected together to VPP of ICSP with two 10K to ground. My reset resistor was also 10K so i had 1.5V. Finaly i put a diode on VPP and i have 5 V on reset input and my PIC restart after p...
- Fri Apr 24, 2015 3:21 pm
- Forum: Microchip
- Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
- Replies: 132
- Views: 254813
Re: Pic - K150 ICSP Programmer (HCDVBD0002)
Thanks for your reply.
I tried with your software (that is the same as mine), same problem so it is hardware of TS-8900 K150. But it is not so bad, i just have to connect and disconnect ICSP connector each time i program the PIC. It works fine for the other.
Cheers
Yves
I tried with your software (that is the same as mine), same problem so it is hardware of TS-8900 K150. But it is not so bad, i just have to connect and disconnect ICSP connector each time i program the PIC. It works fine for the other.
Cheers
Yves
- Wed Apr 22, 2015 2:22 pm
- Forum: Microchip
- Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
- Replies: 132
- Views: 254813
Re: Pic - K150 ICSP Programmer (HCDVBD0002)
Thanks for your reply. My card has a 16F628A, the same as the K150 programmer , my Microburn software is V150807 version with P18A protocol. The programmer is a TS8900-K150 with P18A firmware. All works fine, i can program also by ICSP but i have to disconnect ICSP connector to run the card, if not ...
- Tue Apr 21, 2015 7:41 pm
- Forum: Microchip
- Topic: Pic - K150 ICSP Programmer (HCDVBD0002)
- Replies: 132
- Views: 254813
Re: Pic - K150 ICSP Programmer (HCDVBD0002)
Hello,
I have a K150 since a week, it works and it can also program PIC by ICSP. Just one thing, is there a solution to let ICSP connected after programming, when PIC is running. I have to disconnect ICSP to run my PIC card , it would be fine to let K150 connected.
Cheers
Yves
I have a K150 since a week, it works and it can also program PIC by ICSP. Just one thing, is there a solution to let ICSP connected after programming, when PIC is running. I have to disconnect ICSP to run my PIC card , it would be fine to let K150 connected.
Cheers
Yves